Hi all,
I'm having a bit of trouble with Helical Sweep in Creo 1.0. I sketched the sweep profile on the side face of an extrusion, making the sketch a child of the face (and the line that defined the face). After making the sweep, I went back and deleted the original line (see below error)and then resketched it, causing the sweep to fail. Okay so far.
View attachment 5218
When I accept the regeneration, the next logical step would be to edit the definition of the sweep in order to change the profile sketch reference. Each time I click "Edit Definition" Creo informs me the feature failed to regenerate, but never actually lets me edit the definition.
View attachment 5219
Anyone have any advice on this? See attached. 2011-07-01_160137_prt0001.prt.zip
I'm having a bit of trouble with Helical Sweep in Creo 1.0. I sketched the sweep profile on the side face of an extrusion, making the sketch a child of the face (and the line that defined the face). After making the sweep, I went back and deleted the original line (see below error)and then resketched it, causing the sweep to fail. Okay so far.
View attachment 5218
When I accept the regeneration, the next logical step would be to edit the definition of the sweep in order to change the profile sketch reference. Each time I click "Edit Definition" Creo informs me the feature failed to regenerate, but never actually lets me edit the definition.
View attachment 5219
Anyone have any advice on this? See attached. 2011-07-01_160137_prt0001.prt.zip