drw- asm- prt association

[boydt]

I am running 2001 without Intralink. Here is my question



I made a model (part) then put it in my assembly and then made a drawing of that part. I later decided to change the name of that part. I had the assembly in ram when I did this so it updated in my assembly just fine but now my drawing is looking for the old part that does not excist anymore. I re-created that part by copying the new # and renaming it to the old #. My drawing will open but now I have two parts of the same thing. How can I get my drawing to look fo the new part # ?????



Thank you

www.geocities.com/btsandsports

 

[extreme]

You need to have all 3 up in session. Do the prt first, then regen the asm, then rename the drawing