Drop test procedure

[vikas02121]

Hi All,


This is my first post on this forum. I have a electric tooth brush assembly that has cells, electric componentsand two plastic enclosures that encloses the cells and the electric components andare ultra-sonic welded.


-How can I perform the drop test???


-Do I have to give mass and material properties of each component(this would be a mammoth task)?


Please explain the procedure. I have claimed in my office that it could be done using Pro/Mechanica.


Help !!! Help!!! Help!!!!


- NickelBack

 

[Natewebb]

Suggested Technique For Effectively Analyzing Impact


http://www.ptc.com/cs/cs_22/howto/mst2742/mst2742.htm


The bad news is the results are qualitative, I wouldn't trust them quantitatively. Pro/Mech is not the best tool for the job.