Ripper2009
New member
Hi all.
Ihave been tryingto create a chart that would allow me to select a drill size, to creating a feature, but when the feature is display on the drawing, I would like it to control the tolerance range of the hole.
Example
I would pick 1/4 drill from the chart, and on the drawing it would display as the following Dia. symbol .248-.247.
Can anyone give any advice?
Thanks in advance,
Rip
Ihave been tryingto create a chart that would allow me to select a drill size, to creating a feature, but when the feature is display on the drawing, I would like it to control the tolerance range of the hole.
Example
I would pick 1/4 drill from the chart, and on the drawing it would display as the following Dia. symbol .248-.247.
Can anyone give any advice?
Thanks in advance,
Rip