Drawing ray

[Geof]

Hi,

I'm a new user of ProE. I'm trying to draw a disk with ten ray distribute equaly on it in 3D. First I had draw a disk and I'm able to draw the ray on the axis. I draw it with rectangle tool. But I'm not able to draw ray between the axis because I'm not able to rotate the rectangle.

What is the good way to do that?

Thank you

 

[jrobi]

WHEN YOU ARE CONSTRUCTING THE "RAY", PLACE A CONSTRUCTION LINE TO CONSTRAIN TO. INITIALLY, PLACE IT ON AN ANGLE, ANY ARBITRARY ANGLE, AND MODIFY THAT ANGLE TO 0 DEGREES. WHEN PATTERNING, SELECT THAT O DEGREE DIMENSION TO DRIVE YOUR PATTERN. IF IN WILDFIRE, USE AXIS MAY BE YOUR BEST BET.