Dimensions !! problem...

[jasmeet11arora]

Hello !



I am facing problem with dimensions. I made a curve using equations.....i know that when i will mention 360 degrees, pro/E will not accept but i want to be very much close to 360 degrees n then i gave 359.5 and pro/E is accepting that. when i tried to be more close i gave 359.6 and here the problem comes..pro/E is again rejecting this value but accepting 359.59 but not 359.60



Now wat shall i do to be more precise (more close to 360 degrees) ?? suggest, please

 

[Moroso]

Try tightening up your part accuracy.

 

[jasmeet11arora]

I truly dont have any idea bout tightening the part accuracy, can you explain a bit, please

 

[jasmeet11arora]

is it something, that i need to go to the set up > accuracy in assembly and change the default value 0.0012 to something lower ??

 

[Moroso]

Do it in part mode, lower the accuracy there ex .0005

 

[jasmeet11arora]

thanks moroso...i m doing it..lets see if my main problem get solve by tightening the part......

 

[jasmeet11arora]

I wonder...its still not accepting 359.60

i gave the accuracy value 0.0005 ...is it something else which is creating problem ???