I am new to Expert Machinist and am trying to make a Top Chamfer Feature on the Model below.
View attachment 1350
I can get it to do everything, but I can't control the depth of the cutter. The depth is shown by the red line in the image below. If I allow the default value generated by the software the tip of my tool gets into the vise jaws holding the part.
View attachment 1351
What value do I change and where is it located.
Thanks in advance......
View attachment 1350
I can get it to do everything, but I can't control the depth of the cutter. The depth is shown by the red line in the image below. If I allow the default value generated by the software the tip of my tool gets into the vise jaws holding the part.
View attachment 1351
What value do I change and where is it located.
Thanks in advance......