I'm using Design Data Manager and when it saves a model it creates and saves a screenshot.
The problem is that it re-orients and resizes the view when it does this and I often end up with a small image of the model in the middle of a large grey area. I think this is because of the mapkey that is used to initiate the command. I've tried to edit the mapkey to remove the "ProCmdViewDefault.view" part but it doesn't seem to work. I'd be grateful if someone could give me a few pointers on what exactly I should remove.
The mapkey copied from the config.pro is shown below:
mapkey ddm05 @MAPKEY_NAMEGenerate preview image from screen capture;\
mapkey(continued) @MAPKEY_LABELPreview;~ Activate `main_dlg_cur` `ProCmdViewDefault.view`;\
mapkey(continued) ~ Select `main_dlg_cur` `ProCmdEnvMdlDisp.mdisp`1 `Shading`;\
mapkey(continued) ~ Select `main_dlg_cur` `MenuBar1`1 `PDMI: DDManager`;\
mapkey(continued) ~ Close `main_dlg_cur` `MenuBar1`;~ Activate `main_dlg_cur` `PDMI: Preview`;
Many thanks,
Sam
The problem is that it re-orients and resizes the view when it does this and I often end up with a small image of the model in the middle of a large grey area. I think this is because of the mapkey that is used to initiate the command. I've tried to edit the mapkey to remove the "ProCmdViewDefault.view" part but it doesn't seem to work. I'd be grateful if someone could give me a few pointers on what exactly I should remove.
The mapkey copied from the config.pro is shown below:
mapkey ddm05 @MAPKEY_NAMEGenerate preview image from screen capture;\
mapkey(continued) @MAPKEY_LABELPreview;~ Activate `main_dlg_cur` `ProCmdViewDefault.view`;\
mapkey(continued) ~ Select `main_dlg_cur` `ProCmdEnvMdlDisp.mdisp`1 `Shading`;\
mapkey(continued) ~ Select `main_dlg_cur` `MenuBar1`1 `PDMI: DDManager`;\
mapkey(continued) ~ Close `main_dlg_cur` `MenuBar1`;~ Activate `main_dlg_cur` `PDMI: Preview`;
Many thanks,
Sam