MatthewJB19904
New member
Here is what I am trying to do: When you make a flat wall, you get prompted for the inside bend radius. The options are thicknes/2, thickness*2, thickness or enter value. I want to be able to show thickness*.63 as an option. There is also a cell in the bend table that shows a default value of 1.25 (in ours anyway) which also shows up in the pull down. I tried to enter this formula in its place but I get an error.
The default parameter for the sheetmetal module provides some usability but since each wall created has its own id, I can't lock down a relation for them all. (too time consuming) The bend radius is not always the same but 90% of the time I can apply thickness*.63 for the inside bend radius. Just looking a for a way to be able select this little formula for a bend radius. Any help would be greatly appreciated.
The default parameter for the sheetmetal module provides some usability but since each wall created has its own id, I can't lock down a relation for them all. (too time consuming) The bend radius is not always the same but 90% of the time I can apply thickness*.63 for the inside bend radius. Just looking a for a way to be able select this little formula for a bend radius. Any help would be greatly appreciated.