Fix your @$%*&! sketcher constraints! The supposed conflicts shown are not actual conflicts. If fact, in the situation I am looking at right now, there are no conflicts. Yet I can't create the geometry I need. All I want is an arc which is tangent to two lines. The radius of the arc is undefined (it can be whatever radius is required). The arc can attach to the lines anywhere. After trying 10 different ways to do a very simple thing I finally succeeded. When a 3 second task turns into a 10 minute task productivity is reduced by a factor of 200.
You've been at this for 35 years and your software is still an EPIC FAILURE! In fact sketcher constrains used to work fine, which means the software is getting worse.
You've been at this for 35 years and your software is still an EPIC FAILURE! In fact sketcher constrains used to work fine, which means the software is getting worse.