cutter comp error

[maxlobo2]

The first 2 lines shown below are causing a cutter comp fault in a CNC machine in my shop. They are being generatedby 2 similargoto points in my cl data. Is this something I can correct in the mfg file or is this a post issue?


TIA


N1150X-3.6405Y2.4281Z1.6801


N1160X-3.6406Z1.68


GOTO / -3.6405287145, 2.4281084189, 1.6801136749


GOTO / -3.6406107268, 2.4281159889, 1.6800000000

 

[Don.Rhea]

Your question/information is to vague.


Does the machine allow Z movement while in Cutter Comp? I do not see a G01 in block N1150. Is it in linear mode>


If you will e-mail me the .NCL, UNCX01.Fxx and UNCX01.Pxx files I will see if I can help.


E-mail: [email protected]


Don

 

[maxlobo2]

Yes, the lines I have shown are G1 lines. If I delete one of the lines - the machine will run without faults. Here's the beginning of the sequence with the 2 lines at the end. Don, please check your e-mail.


Thanks
N1050G90G55G00X-10.8709Y-.2999S6500M03<?:namespace prefix = o ns = "urn:schemas-microsoft-comfficeffice" />
N1060G43Z1.78H11
N1070G01G41X-10.8597Y.9F30.D11
N1080G02X-9.8062Y2.0411I1.4697J-.3
N1090X-3.9471Y2.4729I3.9543J-13.6904
N1100G01X-3.883Y2.464Z1.7762
N1110X-3.8198Y2.4551Z1.7644
N1120X-3.7586Y2.4462Z1.7449
N1130X-3.7003Y2.4374Z1.7179
N1140X-3.6457Y2.4289Z1.6839
N1150X-3.6405Y2.4281Z1.6801
N1160X-3.6406Z1.68

 

[appinmi]

It could be that in line 1160, the tool is only moving .0001 in X and .0001 in Z. If you cutter comp value is greater than .0001, it cannot compensate for such a small move.