Our office went from WF4 to Creo 2 yesterday. There are some commands that we did in WF4 but can't figure out where the commands are in Creo 2. When we worked on large assemblies we would often design a part using copy geometry so we would know the boundaries of the part. Here is what we picked in WF4 to copy geom:
Tools / Assembly Settings / Reference Control / External Reference Control / Global Environment Settings / then picked "ALL"
In the assembly we would activate the part then pick:
Insert / Shared Data / Copy Geometry Then we picked the features we needed to copy.
Question is; where is this done in Creo 2? Is there an advance assembly module we need? TIA for your help.
Tools / Assembly Settings / Reference Control / External Reference Control / Global Environment Settings / then picked "ALL"
In the assembly we would activate the part then pick:
Insert / Shared Data / Copy Geometry Then we picked the features we needed to copy.
Question is; where is this done in Creo 2? Is there an advance assembly module we need? TIA for your help.