Using WF 2.0, the new feature of saving the DWG as a PDF document is a nice addition. It's nice that it is automated to save the PDF as the correct sheet size, B, C, D, or whatever.
However, I have one thing I'd like to change or add to this automated process. We store our drawings as PDF files currently, actually since using ver. 2001, and we put a letter after the filename to indicate the revision level. This same revision letter is found in the drawing, as expected, and is done so with use of the parameters.
Is there a way to save the PDF filename with this parameter's value on the end of it? I'd envision the code would be something to the effect of:
Save as <filename><rev>
Where <filename> and <rev> are the parameters for each respective value.
Any ideas on how to do this? Would like to eliminate the manual (and boring) process of renaming all of our drawings.
However, I have one thing I'd like to change or add to this automated process. We store our drawings as PDF files currently, actually since using ver. 2001, and we put a letter after the filename to indicate the revision level. This same revision letter is found in the drawing, as expected, and is done so with use of the parameters.
Is there a way to save the PDF filename with this parameter's value on the end of it? I'd envision the code would be something to the effect of:
Save as <filename><rev>
Where <filename> and <rev> are the parameters for each respective value.
Any ideas on how to do this? Would like to eliminate the manual (and boring) process of renaming all of our drawings.