Creating a datum plane using wildfire

[KHECKEL]

Having problems creating a datum plane in wildfire... once i select the first reference (say through a cylinder) how do i add another, say, to specify an angle from another datum plane???

 

[zachlee]

is wildfire seem good or does 2001 seem better, more buttons.

i am just looking for a response to see if wildfire is good or a solid works related button copy

 

[miked]

I have been using it for a couple weeks and I would hate to switch back to 2001. Iam much quicker with wildfire, there are way fewer steps than before.

Try picking up an upgrade book for reference first if you can

Mike

 

[sajo]

It is like Hanns said. Hold down CTRL. I think you sometimes have to change from offset to something else.