Hi all,
This is my very first time of using Pro Engineer 5.0, and
I did search a lot before posting a question in here.
I've been using Solidworks and Inventor for 2 years up
till now and I'm pretty sure my level is above average.
But now I have to use Pro Engineer due to new customer.
Actually, I got some training and can do some part
modeling with few fundamental features (extrude, cut,
hole, etc...).
Right now, I got stuck with how to create a center line
right in a middle between 2 reference lines.
The first idea that came up in my mind is using offset
command, I can measure the distance between 2 lines and
draw a line in the middle, but then I have to convert
that line into reference (because Pro E won't accept
incomplete sketch).
Excuse for my English, but please give me some idea for
how and what command should I do.
Thanks all
This is my very first time of using Pro Engineer 5.0, and
I did search a lot before posting a question in here.
I've been using Solidworks and Inventor for 2 years up
till now and I'm pretty sure my level is above average.
But now I have to use Pro Engineer due to new customer.
Actually, I got some training and can do some part
modeling with few fundamental features (extrude, cut,
hole, etc...).
Right now, I got stuck with how to create a center line
right in a middle between 2 reference lines.
The first idea that came up in my mind is using offset
command, I can measure the distance between 2 lines and
draw a line in the middle, but then I have to convert
that line into reference (because Pro E won't accept
incomplete sketch).
Excuse for my English, but please give me some idea for
how and what command should I do.
Thanks all