Hi guys,
Im trying to create a hollow trapezium in sheetmetal, but I'm having problems blending the corners. The two long sides has a different angle than the short side. (See picture below)
Any good technic to build this part.
BTW: The part in the picture was buildwith an extrude-draft and shell feature, but it can not be true that I can not make it in sheetmetal. Hope you can help me
View attachment 3946
Im trying to create a hollow trapezium in sheetmetal, but I'm having problems blending the corners. The two long sides has a different angle than the short side. (See picture below)
Any good technic to build this part.
BTW: The part in the picture was buildwith an extrude-draft and shell feature, but it can not be true that I can not make it in sheetmetal. Hope you can help me
View attachment 3946