config:- Angular_Tolerance

[jbuckl]

Can a smaller tolerance be forced into existing models?

 

[rudresh.hm]

please state the problem description clearly! can you elaborate a little.
Edited by: rudresh.hm

 

[jbuckl]

Ok.


Angular Tolerance is a config setting.(0.0;0.00;0.000;0.0000;0.00000 etc)


A changeto this config setting affects new models.


I want to know if a change can be forcedto work on older models.

 

[dr_gallup]

No. The setting only affects newly created dimensions. Think about it. Would you want the setting to retroactively change every dimension on a part you just finished detailing with 100 shown dimensions? Probably not.

One thing you can do is show all the dimensions on a drawing, select all of them (or just the ones you want to change) and change the number of decimal places and tolerance all at once without changing the nominal value.