Hi, me again...
I have a part that is basically a cuboid but it's sides are not parallel with the front and right planes (ie it's been created as if it's been rotated around an axis normal to the top plane) and when i create a drawing of it, the side and top views are also twisted.
is there any way to rectify this so that they are not twisted without re-doing the part? (this would take some time)
thanks
chris
I have a part that is basically a cuboid but it's sides are not parallel with the front and right planes (ie it's been created as if it's been rotated around an axis normal to the top plane) and when i create a drawing of it, the side and top views are also twisted.
is there any way to rectify this so that they are not twisted without re-doing the part? (this would take some time)
thanks
chris