Hello to all,
I created a drawing which has both the 3D cable assy and the flat(mfg) harness assy. then I when back into the 3D cable and added a bundle to represent a short lengthof shrink tubing.
When routing the bundle I used a csys wherea couple of individual conductors route thru. I did not have a location to use where the tubbing ends so I used a free location on an axis that is used to route the whole cable.
In the 3D cable the tubbing looks great just like the actual cable. but it does not show up in the Flat harness assy. So I think to myself maybe I need to lay it out, but when I select the free location on the axis; it tells me that I can not layout locations that are not used in routing the cable/wires.
My question is: do I need to go back and add a location to the routing or am I doing some else wrong? hoping not to add a location becuase the axis is used to route the cable thru a conduit that retains it to a casting. The tubing just happens to end somewhere in the middleof theconduit.
Any help would be very much appriciated. Trying to teach myself cabling and having just a few troubles. currently just using manual routing, will dive into RSD lite after I hammer out the few troubles.
Thanks Jim
I created a drawing which has both the 3D cable assy and the flat(mfg) harness assy. then I when back into the 3D cable and added a bundle to represent a short lengthof shrink tubing.
When routing the bundle I used a csys wherea couple of individual conductors route thru. I did not have a location to use where the tubbing ends so I used a free location on an axis that is used to route the whole cable.
In the 3D cable the tubbing looks great just like the actual cable. but it does not show up in the Flat harness assy. So I think to myself maybe I need to lay it out, but when I select the free location on the axis; it tells me that I can not layout locations that are not used in routing the cable/wires.
My question is: do I need to go back and add a location to the routing or am I doing some else wrong? hoping not to add a location becuase the axis is used to route the cable thru a conduit that retains it to a casting. The tubing just happens to end somewhere in the middleof theconduit.
Any help would be very much appriciated. Trying to teach myself cabling and having just a few troubles. currently just using manual routing, will dive into RSD lite after I hammer out the few troubles.
Thanks Jim