bend allowance or bend tables

[chill2001]

I have been asked to evaluate about 12-15 sheet metal models that were created in Pro/E 2000i.
<?:namespace prefix = o ns = "urn:schemas-microsoft-comfficeffice" />
I need to determine if a bend table or a bend allowance formula was used in the creation of these parts, and if so to define the specific table or the specific formula.

My question is how can I tell? Where do I need to look?


I can use either a 2000i or wildfire 2 to complete this task.

 

[mudassirkhan]

hi, you can go to setup-sheet metal-bend table-


here u can see which bend table is been applied.