Assembly won’t AutoGEM

[babbel]

When I try to AutoGEM a small assembly I get an error message. I've tried autoGEM on each part individuallywith no problem.


The error message just says "error or warnings encountered and were logged in the log file".


Any idea what the error or warning could be? I can't find the file!


Thanks in advance.


Jon

 

[Luis Aguirre]

Jon,


Most of the time, parts are easy to mesh. However, when it comes to assembly you must be more careful. If you have access to PTC customer support website look at the following suggested techniques:


Suggested Technique for Preparing Pro/ENGINEER Geometry for Successful AutoGEM in Pro/MECHANICA


http://www.ptc.com/cs/cs_24/howto/mst698/mst698.htm


Suggested Technique for Troubleshooting AutoGEM Issues in Pro/MECHANICA


http://www.ptc.com/cs/cs_24/howto/mst1237/mst1237.htm


Luis

 

[ice_man]

Jon:

Did you check the interference between the parts in your assembly? If you have interfering parts, that's the type of error you usually get. Let me know how it goes.

Cheers

Harshal

 

[soccer8888]

I tried going to those links but it says my username isn't allowed in that area. Is that a premium service or something?

 

[ndk]

You need a customer's ID to pass through