Hello, new to the forum.
I am using Wildfire 5 and have been a Pro E user for about 6 years. I just started a new position that only has one seat of Pro and all parts are stored completely on the hard drive. I am used to a multi seat set up with a server.
When I started this new position, I started on an old computer and had to suffer through 3 weeks of slow graphics and crashes. Finally now I have my new computer and am setting everything up. I have an assembly that after moving all the parts from the old hard drive to the new one is having problems locating parts. I open the assembly and right click on the part to locate it's new location and slowely the assembly is complete again. Then I save. Done for the day I shut everything down for the night and when I open the assembly in the morning...I have to redefine all the part locations again. How can I prevent this happening everytime I close/open the assembly?
I am using Wildfire 5 and have been a Pro E user for about 6 years. I just started a new position that only has one seat of Pro and all parts are stored completely on the hard drive. I am used to a multi seat set up with a server.
When I started this new position, I started on an old computer and had to suffer through 3 weeks of slow graphics and crashes. Finally now I have my new computer and am setting everything up. I have an assembly that after moving all the parts from the old hard drive to the new one is having problems locating parts. I open the assembly and right click on the part to locate it's new location and slowely the assembly is complete again. Then I save. Done for the day I shut everything down for the night and when I open the assembly in the morning...I have to redefine all the part locations again. How can I prevent this happening everytime I close/open the assembly?