I have been reading over everyone else who has a similar issue on this site and the PTC site and I cant figure out what I am doing wrong. When I attempt to make a PDF from a drawing an an A4 sized paper the entity lines are much too thick and destroys the detail. From other users to my understand this is what I figured would work(I am using creo 2.0):
use_8_plotter_pens yes
pdf_use_pentable yes
pen1_line_weight 1
all they way to
pen8_line_weight 1
All 8 pens have the thinnest value of 1, pdf uses pentable, and I am using 8 plotter pens, yet when I create the .pdf it continues to have thick lines on the entity edges.
Im not sure if the attachment is going to show in full resolution but it is just a configuration options of the values that I already posted. If there is something else i should be doing can someone please let me know, I am wasting too much time trying to figure something that seems to be simple out.
use_8_plotter_pens yes
pdf_use_pentable yes
pen1_line_weight 1
all they way to
pen8_line_weight 1
All 8 pens have the thinnest value of 1, pdf uses pentable, and I am using 8 plotter pens, yet when I create the .pdf it continues to have thick lines on the entity edges.
Im not sure if the attachment is going to show in full resolution but it is just a configuration options of the values that I already posted. If there is something else i should be doing can someone please let me know, I am wasting too much time trying to figure something that seems to be simple out.