Brett Bellmore
New member
I've been running into this problem lately, it comes and goes: I'll get a radius on a revolved part, put on as a round, or in the original sketch, and no matter how close I zoom in before picking on it in the drawing, it always selects one END of the radius, and thus I can't put a radius dimension on it.
For what it's worth, this doesn't appear to happen if I'm dimensioning a cross section rather than a regular view. Probably why I never noticed it before, I'm usually using cross sections to show internal features of my revolved parts, and just hit a run of parts without internal features.
Any idea what's going on?
For what it's worth, this doesn't appear to happen if I'm dimensioning a cross section rather than a regular view. Probably why I never noticed it before, I'm usually using cross sections to show internal features of my revolved parts, and just hit a run of parts without internal features.
Any idea what's going on?