Hi.
After a long chain of grief I finally managed to make WF3 install and run in SuSE Linux 10.1! For all of five minutes and then the whole computer hung hard.
Someone told me the ATI 8.25 drivers for my FireGL are bad so I worked for an hour until I got 8.24 to work.
Then I found that the PTCSETUP utility for FlexNet all of a sudden decided to change the NIC that my license is tied to. I have two NICs in my computer, one integrated on the mobo that is connected to the network and another PCI NIC that is used only for the license. Now PTCSETUP demands that my license be tied to the integrated NIC. >_<
Any ideas on how the heck I get around this? Can I point to a certain NIC in PTCSETUP?
Or should I reassign eth0 & eth1 in SuSE in some way? They do look like they did when I installed the system in the first place, but it is hard to tell if something got changed.
After a long chain of grief I finally managed to make WF3 install and run in SuSE Linux 10.1! For all of five minutes and then the whole computer hung hard.
Someone told me the ATI 8.25 drivers for my FireGL are bad so I worked for an hour until I got 8.24 to work.
Then I found that the PTCSETUP utility for FlexNet all of a sudden decided to change the NIC that my license is tied to. I have two NICs in my computer, one integrated on the mobo that is connected to the network and another PCI NIC that is used only for the license. Now PTCSETUP demands that my license be tied to the integrated NIC. >_<
Any ideas on how the heck I get around this? Can I point to a certain NIC in PTCSETUP?
Or should I reassign eth0 & eth1 in SuSE in some way? They do look like they did when I installed the system in the first place, but it is hard to tell if something got changed.