2008-07-28_064902_hopper.zip
Can anyone help unbend the attached part.
It's a special purpose hopper, created from a blend. Only problem is the top blend is not rectangularas per the bottom blend. The top blend hasone corner off on an angle. The unbend command will not work for this corner. I have tried deformation, but I cant seem to get any result to unbend.
Can anyone help create a blank pattern?
Can anyone help unbend the attached part.
It's a special purpose hopper, created from a blend. Only problem is the top blend is not rectangularas per the bottom blend. The top blend hasone corner off on an angle. The unbend command will not work for this corner. I have tried deformation, but I cant seem to get any result to unbend.
Can anyone help create a blank pattern?