Hi guys
This is my first topic on this forum, i'm not a god englishman, so sry if i miss some words.
I need to do a thread turning of metric thread (60 deagres). Thread is M58x2 and everythnig about this sequence is clear to me (i think) except one parameter, THREED_FEET. It says that THREED_FEED is thread pitch in THREAT_FEED_UNITS. I set THREAT_FEET_UNITS to MMPR. Why i need THREAD_FEED? If that is a pitch, may I set CUT_FEED to 240 and SPINDLE_SPEED to 120 to get a pitch od 2mm?
Plz give me a advice or some example to these parameters.
Tnx ahead
This is my first topic on this forum, i'm not a god englishman, so sry if i miss some words.
I need to do a thread turning of metric thread (60 deagres). Thread is M58x2 and everythnig about this sequence is clear to me (i think) except one parameter, THREED_FEET. It says that THREED_FEED is thread pitch in THREAT_FEED_UNITS. I set THREAT_FEET_UNITS to MMPR. Why i need THREAD_FEED? If that is a pitch, may I set CUT_FEED to 240 and SPINDLE_SPEED to 120 to get a pitch od 2mm?
Plz give me a advice or some example to these parameters.
Tnx ahead