john_erlandsson
New member
Hi!
I'm new to PROE and new to this forum.
Running proe wildfire 3.0 on Fedora 14
My config.pro file doesn't seem to load properly.
I added:
pro_unit_sys mmks
pro_unit_length unit_mm
pro_unit_mass unit_kilogram
to /home/john/config.pro
but when i create a new part it is always in inches.
I then tried to add a bogus line:
test hello
and started proe from the command line.
This gave me an error message saying:
/home/john/config.pro, linenum 5 : Keyword 'TEST' is not valid.
So I take it that proe reads my config.pro file, but doesn't save the values
any ideas?
Edited by: john_erlandsson
I'm new to PROE and new to this forum.
Running proe wildfire 3.0 on Fedora 14
My config.pro file doesn't seem to load properly.
I added:
pro_unit_sys mmks
pro_unit_length unit_mm
pro_unit_mass unit_kilogram
to /home/john/config.pro
but when i create a new part it is always in inches.
I then tried to add a bogus line:
test hello
and started proe from the command line.
This gave me an error message saying:
/home/john/config.pro, linenum 5 : Keyword 'TEST' is not valid.
So I take it that proe reads my config.pro file, but doesn't save the values
any ideas?
Edited by: john_erlandsson