demosselman
New member
Hey there,
I am pretty new to Solidworks. student with 6 months
experience. To get some practice is decided to start
surfacing a car. I have been running into some errors
however.
I was hoping that some experienced user might be able to
help me out.
I am surfacing this car by drawing 2d lines and combining
them in a 3d project curves. Between these curves I make
a boundary surface.
I make sure the endpoints of all the curves connect
precisely. Yet for some reason gaps keep showing up
between the panels I model.
When is select a 2nd guide curve it says **error** and
the gap just stays there, It wont become tangeant to the
panel that is next to it.
I posted some images so you know what i am talking about.
http://img20.imageshack.us/i/camaroerror.png/
http://img684.imageshack.us/i/camarogap.png/
http://img860.imageshack.us/i/camaro.png/
I hope you can provide me with some help.
I am pretty new to Solidworks. student with 6 months
experience. To get some practice is decided to start
surfacing a car. I have been running into some errors
however.
I was hoping that some experienced user might be able to
help me out.
I am surfacing this car by drawing 2d lines and combining
them in a 3d project curves. Between these curves I make
a boundary surface.
I make sure the endpoints of all the curves connect
precisely. Yet for some reason gaps keep showing up
between the panels I model.
When is select a 2nd guide curve it says **error** and
the gap just stays there, It wont become tangeant to the
panel that is next to it.
I posted some images so you know what i am talking about.
http://img20.imageshack.us/i/camaroerror.png/
http://img684.imageshack.us/i/camarogap.png/
http://img860.imageshack.us/i/camaro.png/
I hope you can provide me with some help.