Hello
Im new to solidworks and im running into a bit of a problem. I
sketched a profile in the side view and another in the front view. when
i switch to 3/4 view there off. i want to be able to snap the right
profile sketch to a mid point of the front one. they are 2 separate
sketeches cause one is extruded to a solid and the right profile is a
cut out from the center. how do i go about doing this, it seems like an
easy operation with an easy answer. also i can just select the top face and choose cut becasue the hole isnt uniform
Edited by: idtjes3
Im new to solidworks and im running into a bit of a problem. I
sketched a profile in the side view and another in the front view. when
i switch to 3/4 view there off. i want to be able to snap the right
profile sketch to a mid point of the front one. they are 2 separate
sketeches cause one is extruded to a solid and the right profile is a
cut out from the center. how do i go about doing this, it seems like an
easy operation with an easy answer. also i can just select the top face and choose cut becasue the hole isnt uniform
Edited by: idtjes3