Does anyone have
suggestions of how to get the pin (on the lower swashplate) to follow
the guide (the tall black piece with the slot). I can't seem to
do it with the parts shown and only suspect (new to mechanism stuff)
that I'll need to add invisible parts to make this work.
Forgot to add: The swash should move up and down and tilt in X
and Y direction. I can add callouts if the pic or terms are clear.
Thanks in advance
View attachment 1207
Edited by: rotorcam
suggestions of how to get the pin (on the lower swashplate) to follow
the guide (the tall black piece with the slot). I can't seem to
do it with the parts shown and only suspect (new to mechanism stuff)
that I'll need to add invisible parts to make this work.
Forgot to add: The swash should move up and down and tilt in X
and Y direction. I can add callouts if the pic or terms are clear.
Thanks in advance
View attachment 1207
Edited by: rotorcam