I'm trying to figure out how to effectively use the
Layout sketching tool in an Assembly. I understand the
whole idea behind creating blocks and making those blocks
into parts by extruding/revolving them.
But, what I can't figure out is how to control where the
coordinate frames are positioned within the part when I
"create part from block"
It seems like each block has a unique origin within the
block, and it would make sense if that origin controlled
where the origin planes were set. But, I can't seem to
find out how to control this.
Any ideas?
Layout sketching tool in an Assembly. I understand the
whole idea behind creating blocks and making those blocks
into parts by extruding/revolving them.
But, what I can't figure out is how to control where the
coordinate frames are positioned within the part when I
"create part from block"
It seems like each block has a unique origin within the
block, and it would make sense if that origin controlled
where the origin planes were set. But, I can't seem to
find out how to control this.
Any ideas?