Mech_Engineer
New member
I am following the cell phone front cover tutorial in WF3 to create a curved extruded earpiece cut as shown below. This extrude cut creates a curved cut at a corner of a rectangular extrusion.The feature fails and I get the error message:Unattached EXTRUDE_4 was detected.
I have used tangent constraint on the lower entity and align end point and line on the upper. Using ver 2001 in the past, company practice was to not use "open" cuts , but to "close" or extend the cut outside the model to prevent this type of failure. When I do a close cut by adding horizontal and vertical entities the feature creation is successful. Is there something I am doing wrong in the tutorial with the open cut?
Edited by: Mech_Engineer
Edited by: Mech_Engineer