I'm working on 2000i at a new seat... when I create a
X-Section view...only the parts intersected by the arrows
respond to dimensioning or leader notes. Or when I put
my ADTM and arrows out side the assembly..the entire
view does not respond to dimensioning...
I'm using *GENERAL * SECTION * SCALE
is this a config. toggle or is it just me ? Please advise
Thanks,
JMF
X-Section view...only the parts intersected by the arrows
respond to dimensioning or leader notes. Or when I put
my ADTM and arrows out side the assembly..the entire
view does not respond to dimensioning...
I'm using *GENERAL * SECTION * SCALE
is this a config. toggle or is it just me ? Please advise
Thanks,
JMF