Hi,
We have tried to run Mechanica from a Pro/E session started from Intralink. But then we do not get the option to unselect FEM Mode Solver, it is greyed out. It defaults to using FEM Mode Solver (external solvers like Ansys etc.)and when finished placing loads and constraints we cannot run the structure analysys. Any suggestions ? Is this meant to be or have we some wettings wrong ?
Running in Standalone mode works fine (not starting ProE from Intralink). We are using Wildfire 2 M100 and Intralink 3.4.
Thanks,
Matt
We have tried to run Mechanica from a Pro/E session started from Intralink. But then we do not get the option to unselect FEM Mode Solver, it is greyed out. It defaults to using FEM Mode Solver (external solvers like Ansys etc.)and when finished placing loads and constraints we cannot run the structure analysys. Any suggestions ? Is this meant to be or have we some wettings wrong ?
Running in Standalone mode works fine (not starting ProE from Intralink). We are using Wildfire 2 M100 and Intralink 3.4.
Thanks,
Matt