Hi All,
Is there any possibility to reverse post a nc file in NX like in mastercam? I have a repeat order for a mouldwhich was done5-6 years ago on some other software.I dont have the part files in NX. All I have is a bunch of nc files. I want to verify/simulate before running them again.
Best Regards,
Is there any possibility to reverse post a nc file in NX like in mastercam? I have a repeat order for a mouldwhich was done5-6 years ago on some other software.I dont have the part files in NX. All I have is a bunch of nc files. I want to verify/simulate before running them again.
Best Regards,