Reference Book

[matts1]

Hi,

Is there a way to shut off the annoying resizing of sketcher when you do any kind of editing to the sketch? Also, is there a way to lock the dimension locations so they're not all clumped together? I can move them to where they are all separated, but every time sketcher resizes, they clump back together again.

Thanks,

Matt

 

[jay.coker]

hi matt,

set 'sketcher_refit_after_dim_modify' to 'no' in configuration editor, this should sort the dimensions too

regards

 

[matts1]

Thanks for the help Jay. That worked perfectly. Sorry about the thread title. I do need a good book on Creo. The sketch question popped into my mind as I was starting the thread and forgot to change the title.

Matt