Hello all,
I'm currently working on a gearbox project.
I created a simple helical gear with toolbox but AFAIK generated drawing of this model is not standards compliant (Gear teeth are actually not shown on technical drawings)
Is there a workaround?
Here is some screenshots:
http://i40.tinypic.com/2qmjcqt.jpg
http://i43.tinypic.com/977l2f.jpg
Thanks
I'm currently working on a gearbox project.
I created a simple helical gear with toolbox but AFAIK generated drawing of this model is not standards compliant (Gear teeth are actually not shown on technical drawings)
Is there a workaround?
Here is some screenshots:
http://i40.tinypic.com/2qmjcqt.jpg
http://i43.tinypic.com/977l2f.jpg
Thanks