sureshdesigns
New member
Hi all
Im trying to make a part. First I have created asheetmetal flat wall then Iadded a flange by taking driving surface'sedge of the flat wall.Ifliped it in order to get driving surface outside.
The Probelm is when I tried to mirror the flange,it asksfor edge placement I selected driving surface's edge on the other side. Getting a error message could not construct the feature geometry. But when I selected the driven surface (White Surface) the flange got mirroed with opposite direction. After that I have to redefine the sketch always.
Can I get a solution for these.
Im trying to make a part. First I have created asheetmetal flat wall then Iadded a flange by taking driving surface'sedge of the flat wall.Ifliped it in order to get driving surface outside.
The Probelm is when I tried to mirror the flange,it asksfor edge placement I selected driving surface's edge on the other side. Getting a error message could not construct the feature geometry. But when I selected the driven surface (White Surface) the flange got mirroed with opposite direction. After that I have to redefine the sketch always.
Can I get a solution for these.