pro Mechanica installation

[vobboblogs]

i can't seem to be able to use proM
i've design the part with proE successfully..
but the proM can't be use
i've installed it....

 

[vicyun]

Hello,


You installed ProE and ProMechanica...


Now, launch PTCsetup.bat. (Window Explorer, C drive, Program, Wildfire3.0, bin, ptcsetup.bat) (Thisstep is toconnect ProE with ProMechanica.) Keep clicking NEXT until you get to the screen: "Select the optionalconfig. step you with to perform" Check the box for:"Configure the oper product interoperability" ClickNEXT. Type in or select ProMechanica path: c:\programfiles\mechwildfire3.0 ClickCONFIGURE.


There should be no check mark on FEM Mode at Model Type Box pops up.


Cheers,





VYUN

 

[vobboblogs]

thanks....
i'll give it a try. but the license for mechanica is different from pro e right?
and i'm using wildfire 2.0...will the steps be the same