hi to everybody....
i'm working in a post for Fanuc-lathe, but i'm stuck in the development of a "turning cycle contour" ...
if someone has ever worked with fanuc can remember that the G73 is used for that cycle but i stil can't find out how to reach it.
If someone know how to set up please help me ...
i'm also triying to configure the drilling cycles and i've also had many problems.
thnx by your help.
Apok.
i'm working in a post for Fanuc-lathe, but i'm stuck in the development of a "turning cycle contour" ...
if someone has ever worked with fanuc can remember that the G73 is used for that cycle but i stil can't find out how to reach it.
If someone know how to set up please help me ...
i'm also triying to configure the drilling cycles and i've also had many problems.
thnx by your help.
Apok.