harichennai
New member
Hi all,
"Suggested Technique for Creating Table.pnt files and Setting Default Pens ",
If you read this document in PTC knowledge base for ProE, it says about how to do settings in .pnt file,
In my .pnt file , below are the settings for pen 1 and 2,
pen 1 thickness 0.01 cm; dimmed_color letter_color attention_color half_tone_color
pen 2 thickness 0.03 cm; drawing_color
I find that "drawing color" has a place in pen 1 due to default , but also in pen 2 because of my .pnt file (as above),
In such a conflict what happens?
Iam having some problems in getting a correct print from a sheet metal drawing in 2001 ProE,
Thanks in advance
"Suggested Technique for Creating Table.pnt files and Setting Default Pens ",
If you read this document in PTC knowledge base for ProE, it says about how to do settings in .pnt file,
In my .pnt file , below are the settings for pen 1 and 2,
pen 1 thickness 0.01 cm; dimmed_color letter_color attention_color half_tone_color
pen 2 thickness 0.03 cm; drawing_color
I find that "drawing color" has a place in pen 1 due to default , but also in pen 2 because of my .pnt file (as above),
In such a conflict what happens?
Iam having some problems in getting a correct print from a sheet metal drawing in 2001 ProE,
Thanks in advance