PDF output w/Icon

[lairdj]

I ran into this problem recently. I have a drawing with a tolerance on a dimension, tolerance is set to limits. When I create a PDF with the icon, the dims are side by side, not one over the other. When I create a PDF with Print, MS Print Manager, PDFWriter, the print comes out as expected. I've tried many different options using the icon, but I get the same results. I can continue printing with MS Print Manager to get the desired results, but I'm curious as to why I get the results with the icon. Any thoughts? Suggestions?


Thanks.

 

[dgs]

There have been several issues like this with the embedded PDF creation tools. The solution is what you've already discovered - use the old school ways like the PDFWriter or Ghostscript.