PDF export problem

[cklem]

I am having a bit of a proplem exporting a drawing out as a .pdf. When I do this it blocks out part of some of the viewwhere the view windows overlap. I tried printing straight from ProE to our plotter and it did the same thing. Does anyone know what could cause this? If so do you know a solution? Below is a picture of what I am talking about. I am using WF4 datecode M220.


View attachment 5761


All feedback is much appreciated.


Thanks,


Chris

 

[dr_gallup]

Make the lower right a partial view and draw a spline closely around the outside of the geometry. This will help a little but you may still need to move the views farther apart. This only happens with shaded views because Pro/E is sticking a rectangular bit map in for each view and they overlap. The background is white, not transparent so it blocks the other view.