Hello
I'm trying to offset the surface 0.6mmon the attached part to no avail. If i remove the bottom flange that flares up it works ok but then I have to add the flange seperately.
I began by using a revolve and the thicken sketch option but this never worked due to the flange again so I opted for a surface hoping to offset it.
Hope you can help
Thanks
2008-01-31_055336_surface.prt.zip
I'm trying to offset the surface 0.6mmon the attached part to no avail. If i remove the bottom flange that flares up it works ok but then I have to add the flange seperately.
I began by using a revolve and the thicken sketch option but this never worked due to the flange again so I opted for a surface hoping to offset it.
Hope you can help
Thanks
2008-01-31_055336_surface.prt.zip