Hello all,
ifItype&d1[.6] in a cell of a table on a drawing I would expect it to post the value of the dimension and round or trunk the value to 6 decimal places. it doesn't. On my drawing it posts the dim value to three places with [.6] next to it. any suggestions.
the dim in the part is 13 digits long.
WF2 build m240.
ifItype&d1[.6] in a cell of a table on a drawing I would expect it to post the value of the dimension and round or trunk the value to 6 decimal places. it doesn't. On my drawing it posts the dim value to three places with [.6] next to it. any suggestions.
the dim in the part is 13 digits long.
WF2 build m240.