my ExtrusionToolbar vanished and I can’t

[Squidly]

find it anywhere.

What did I do?

I've tried re-starting the computer.

I can sketch just fine, and I've been using SW off and on for a few years for hobby, so I'm not a total newbie.

In existing parts I can open a sketch on a face, draw a rectangle but only "extruded cut/revolved cut" shows.

What did I do to make it hide the extrusion toolbar????

I haven't been doing anything fancy, just plodding through "advanced modeling" of the "hinge".

 

[Raoul-RW]

Hello there,


Is it possible for you to add a picture that shows the problem? As far as I understood, the Features Toolbar is present, but the icon 'Extruded Boss/Base' vanished? If so, add it by going to Tools > Customize > Commands > Features, and drag the 'Extruded Boss/Base'-icon to the Features Toolbar.


Raoul