find it anywhere.
What did I do?
I've tried re-starting the computer.
I can sketch just fine, and I've been using SW off and on for a few years for hobby, so I'm not a total newbie.
In existing parts I can open a sketch on a face, draw a rectangle but only "extruded cut/revolved cut" shows.
What did I do to make it hide the extrusion toolbar????
I haven't been doing anything fancy, just plodding through "advanced modeling" of the "hinge".
What did I do?
I've tried re-starting the computer.
I can sketch just fine, and I've been using SW off and on for a few years for hobby, so I'm not a total newbie.
In existing parts I can open a sketch on a face, draw a rectangle but only "extruded cut/revolved cut" shows.
What did I do to make it hide the extrusion toolbar????
I haven't been doing anything fancy, just plodding through "advanced modeling" of the "hinge".