M Woodhams
New member
Hi All
Hoping you could help me. I have a roller assembly, that I have attached to a spine datum curve, using slot followers.
I want to drive the assembly along the spline at a constant velocity.
Does anyone know how I can do this?
As the roller assembly is only attached to the spline using slot followers I cannot seem to get the motor to use a 'curve length ratio' type driver.
Regards
M Woodhams
Hoping you could help me. I have a roller assembly, that I have attached to a spine datum curve, using slot followers.
I want to drive the assembly along the spline at a constant velocity.
Does anyone know how I can do this?
As the roller assembly is only attached to the spline using slot followers I cannot seem to get the motor to use a 'curve length ratio' type driver.
Regards
M Woodhams