Although most designers cringed at using SW for designing car bodies, I
would like to give it a try. It will make it easier to do CFD and
accurtely place attachement points for the chassis.
Given that, how should I approach this? draw a few sketch
profiles then loft? Then continually insert profiles and relofty
the surface?
thanks
d1
would like to give it a try. It will make it easier to do CFD and
accurtely place attachement points for the chassis.
Given that, how should I approach this? draw a few sketch
profiles then loft? Then continually insert profiles and relofty
the surface?
thanks
d1